I've recently upgraded my remote start system in my 07 Grand Cherokee. What I had was and Autopage remote start unit with and EVO-ALL using 74.08 firmware. All functions worked on that system. I decided to upgrade to a new Compustar CMS7200 unit while keeping the EVO-ALL. During installation, I wanted to check which options I could set in the EVO-ALL using the flash link updater. When I hooked it up, it told me that new firmware is available and 74.35 was recommended. I upgraded the firmware and set the options and tested it out. Everything worked except the remote start. The vehicle would start and run for about 3 seconds and then shutdown. Knowing that my previous system didn't do this, I downgraded back to 74.08 which worked fine. I ended up going between several versions of firmware trying to get the later versions to work. I tried 74.34, then 74.22 and both shutdown the remote start immediately. I also tried 74.14 which worked. During this process, I was trying to troubleshoot the unlock-lock before remote start, so i downgraded to 74.12 noting how 74.14 made the relock faster after unlock before remote start. After this, it told me my unit can't be flashed anymore. So why doesn't the newer firmware work? And can you unlock my EVO-ALL so that I can manage the options in it?
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
